The use of Bricks or Pavers to develop a sidewalk or patio complements a home in a way that is unmatched. In addition, installing a Brick or Paver pathway does not always require a pro.
The key to installing a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are to be installed. The area should be removed a minimum of a foot down, removing all topsoil and clay soil. In addition, string lines should be strung on each side of the walkway. The string lines suggest the completed height of the pathway.
When the location has been dug down, 3/4" gravel stone need to be laid in and tamped down securely. Then 2" of sand, or stone dust should be spread out over the gravel. Once again the sand/stone dust need to be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline need to equate to the thickness of the brick or paver.
Now that you have a steady base, put a 1" pipeline or ledger board the length of the pathway on either side of the sidewalk. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will create a level surface area to lay the bricks/pavers.
Now put on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared area. These strips will act as your pathway border and aid to maintain the stability and shape of the walkway. You can get these plastic strip borders at a lot of house improvement shops. The strips must be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.
When this is done, you can then start to lay the bricks/pavers. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again assist keep the stability of the sidewalk.
When building the walkway, undoubtedly bricks/pavers will need to be cut or split. Unless you desire to purchase or rent an expensive wetsaw, I would recommend buying a basic brick/paver splitter. It is generally a sculpt with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the spot where you desire to break the brick. Utilizing a hammer strike the butt end of the chisel firmly. You may need to do this a couple of times. You might also want to flip the brick/paver over and strike the other side of the brick using the brick making plant hammer and chisle. Within a couple of strikes the brick/paver need to break easily. If your pathway has curves you will require to buy/rent a wetsaw.
After setting up the bricks, build up the outdoors edges with extra sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the brand-new walkway and sweep into the check here fractures. Repeat this procedure a couple of times to guarantee the cracks are completely filled. This will complete the interlocking of the bricks and help to remove any weed growth. Just include yard seed to the outside edges and you should have a gorgeous entryway to your house within a number of weeks.
In addition, setting up a Brick or Paver walkway does not always require a pro. The secret to setting up a Brick or Paver Walkway is to very first properly read more prepare the area where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipe or journal board the length of the walkway on either side of the walkway. These strips will act as your walkway border and assistance to maintain the stability and shape of the sidewalk. Inevitably bricks/pavers will need to be cut or split when constructing the pathway.