Setting up a Brick Paver Walkway or Single Bricks

The usage of Installing a Brick Paver Walkway or Refractory Fire Brick or Pavers to create a pathway or patio area matches a home in a manner in which is unequaled. It adds a level of quality and beauty to a house entrance that can not be attained with either concrete or asphalt. Brick and Pavers also are available in many different colors and shapes permitting for distinct color schemes and patterns to be achieved. In addition, setting up a Brick or Paver walkway does not necessarily need a pro. With some basic knowledge and a relatively basic pathway plan, a property owner can carrying out such a task.

The key to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be set up. In addition, string lines should be strung on each side of the pathway.
As soon as the area has been dug down, 3/4" gravel stone ought to be laid in and tamped down firmly. 2" of sand, or stone dust need to be spread out over the gravel. Again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline ought to equal the density of the brick or paver.

Now that you have a stable base, place a 1" pipe or journal board the length of the sidewalk on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the ready area. These strips will act as your sidewalk border and aid to preserve the integrity and shape of the walkway.

When this is done, you can then start to lay the bricks/pavers. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the pathway.

Undoubtedly bricks/pavers will require to be cut or split when developing the sidewalk. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you desire to break the brick. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop the outdoors edges with extra sand, and after that shovel in the topsoil and load down firmly.
Spread stone dust over the new pathway and sweep into the cracks. This will finish the interlocking of the bricks and help to eliminate any weed development.


In addition, installing a Brick or Paver pathway does not necessarily require a pro. The key to installing a Brick or Paver check here Walkway is to first correctly prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipeline or journal board the length of the walkway on check here either side of the walkway. These strips will act as your pathway border and help to keep the integrity and shape of the walkway. Undoubtedly bricks/pavers will need to be cut or split when constructing the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *